Compound crusher, also known as compound crusher, has the characteristics of large crushing ratio and high output, and is mainly used for secondary or tertiary crushing in mineral processing, coal, building materials, chemical industry, refractory materials, metallurgy, cement, glass, ceramics, electric power and other industries. If you find that your equipment crushed materials have slowed down, please contact the after-sales personnel in time, and today Xiaobian will explain to you the reasons for the slowdown in the crushing process of the composite crusher and the problem handling.
First of all, the clogging of the
compound crusher may be caused by the feeding speed being too fast. When the feed rate is too fast, the load of the compound crusher will increase, resulting in unloading or clogging due to untimely handling. In this case, we should always pay attention to the feed rate of the compound crusher and the indication of the ammeter.
Secondly, when the feed volume is large, the indication value of the ammeter of the
compound crusher is larger. When the rated current exceeds the equipment, it will cause overload operation. In this case, working for too long can cause the motor of the device to clog or even burn out. When this happens, on the one hand, the amount of feed should be immediately reduced, and the feed equipment should be adjusted. Therefore, when choosing equipment, it is necessary to choose the right equipment to ensure that the compound crusher can ensure safe and effective work in the production process.
Third, after the composite crusher works for a period of time, problems such as aging, crushing, meshing and corresponding accessory crushing may occur, or when the crushed material of the composite crusher has a large water content, the discharge equipment may slow down or even block. Issue. In this case, the equipment should be regularly inspected, maintained, and the relevant parts of the compound crusher should be replaced in time. Ensure the safe, stable and efficient operation of the equipment. Generally, the water content of the crusher of the composite crusher should be controlled below 14%. After a period of work, the equipment should be maintained and repaired.
Fourthly, the problem of slow or clogged emissions of the composite crusher is the blocked fan, which may be caused by incompatible conveying equipment. When a problem is found, the fan should be cleaned first, and then the corresponding conveying equipment should be replaced in time, and the equipment should be adjusted to achieve the best fit to ensure the normal and stable operation of the compound crusher. Stable and efficient operation.
The above four points are the reasons for the decline in the crushing speed of the
compound crusher. Finding the root cause of the problem can solve the problem faster before it affects production.
